Consider Adding A Column For The Device Hexadecimal Node ID In Device List

[user837]

Hello everyone,

Occasionally I have come across a situation where a device in the Z-Wave Details routing table will not show the device name. Without a device name, I don't know of another way to correlate the problematic device with the actual device in the device list. In the past I have had to open each device to find the hexadecimal node name.

Would it be possible to have the device hexadecimal node number be listed as a column in the device list See attachment named photograph - 01. it is currently being done in the Z-Wave table? See attachment named photograph - 02?

I recognize the device for many reasons may no longer exist; although, no system changes have been made. Possibilities could include hardware failure, software / driver failure, or even possibly just a dead battery. What I prefer not to do is to simply rip it out. My primary concerns are that I don't know what device I am removing and how it may impact routing.

If there is an alternative way to troubleshoot this issue with require a code change that would be great. Still learning quite a bit about Hubitat.

Thanks for your time and help,
Don

[bertabcd1234]

This is already/still an option. What you're looking for is the "eye" icon at the top to show the DNI column. For Z-Wave devices, this will be the hex node ID.

But there's no reason to go to the Devices page; it's already right on the Z-Wave Details page, too, the ID starring with 0x and that is not inside parentheses (that one being the decimal ID). Maybe that's easier?

[user837]

Thank you so much for your help.

That is exactly what I needed. I didn’t even know that was there, totally overlooked it.

Also, thank you for such a quick response! I very much appreciate your help.

Don