I spent some time reading about RTCGQ13LM and I am a bit confused, seems like there are two operation modes in Zigbee2MQTT : one using the 'standard' Zigbee Coordinator firmware and an ''Aqara native mode which requires an update of the Zigbee stick firmware... Such an update is not possible with HE.
Can you try pairing RTCGQ13LM to HE, switch to this driver, make sure the Debug logs are turned on and send me in a PM the debug logs? I expect that this sensor will send a CheckIn / Heartbeat message approximately every 60 minutes (without being activated by any motion), please make sure such a debug log is included in the logs.
About FP1 (RTCZCGQ11LM) - it is a rather different type of sensor, with many and different configuration parameters, so for HE it will need a dedicated driver. I went this route with Tuya Human Presence sensors (mixing the complex devices with the 'ordinary' PIR sensors in one driver), but I plan to separate these devices in two different drivers... when the time permits in the future.
