Morning everyone,
I was messing with my Kwikset locks yesterday (had some questions in a different thread.) and ultimately removed a few of them and a few switches at the same time.
Now I can't seem to add them back... Out of the several I removed for my project, I have only been able to add back in one switch and one lock... And that took multiple tries...
The hub hangs on "initializing" and never completes the add... I have waited minutes, hours, rebooted the hub, moved it closer, farther, tried different browsers, did factory resets multiple times on the devices, and still no luck...
Also, sometimes when I have abandoned the add, and try again, I get two or three instances of the device all saying "initializing".
Finally, every time I try to add the device again, its incrementally moving the device ID number up. None of these "attempts" have resulted in any new devices in my device list, but I fear they are sitting somewhere occupying that ID...
I even did a database restore from the previous day to see if I could eliminate those phantom missing IDs and start over... That database restore is what seemed to allow me to add the two devices I was able to add back in, but then everything came to a halt...
Also, the incremental numbers started where I had left off, even though I had "restored" the database...
Help! Is my database corrupt? Is the device now messed up? I really hate to say it, but I have thought about removing all 160 devices and starting over with a reset... God I hope that is not what I have to do...