2.2.4 Innovelli 2-Channel Plug

🛎️ Get Help
1

Screen Shot 2020-11-16 at 5.03.10 PM
Screen Shot 2020-11-16 at 5.03.10 PM2058×1174 257 KB

I recently switched from HA to Hubitat based on the great reviews and my lack of time to be a part-time troubleshooter.

I migrated a couple of z-wave plugs, one being the Innovelli NZW37 2-channel plug. I didn't realize it wasn't directly supported before the new release and it was detected as a Zoos 5 channel smart strip. After researching I found it would be supported by 2.2.4 and as soon as I updated changed the drivers. When I did that both switches became available and worked, but now there are 5 leftover "ghost" children from when it was mistakenly identified as the Zoos power strip.

Can these be deleted? Thanks for any help!

2

switch driver to "device" and there is a command button to delete children. Click it, then switch back to the correct driver, and hit CONFIGURE.

2 Likes
3

That did it! Thanks for the quick reply... and I didn't have to edit any yaml!

1 Like
4

Those features on the "device" driver are actually new in 2.2.4. I wouldn't have had such a quick answer before then (although there are user drivers that could do it, so you would not have been SOL, just took more steps).